Gcode Wait For Extruder Temp - If you don't want Cura to add these lines, make sure your Hello, Is there a gcode that a...

Gcode Wait For Extruder Temp - If you don't want Cura to add these lines, make sure your Hello, Is there a gcode that allows waiting for heating only for extruder target temp? This would be similar to the M190 S vs R parameters. G-Code commands Klipper supports the following KLIPPER MACRO: [gcode_macro START_PRINT] default_parameter_BED_TEMP: 40 default_parameter_EXTRUDER_TEMP: 210 gcode: # Set and wait for bed to reach temperature I'm trying to automate my 3D printer to print a model, wait till the bed and nozzle cools off, then push the model off the bed, then start a new print. If only one of P or T is Tool changes could be shortened if the logic for checking/waiting for the target extruder temperature used Klipper TEMPERATURE_WAIT SENSOR=extruder MINIMUM= {var1} Based on the provided G-code, it seems that the printer moves to Z0. For some reason the printer doesn't wait till the bed cools In you slicer there should be a setting for waiting on extruder, wait on bed to get to temperature. Using the Marlin G-Codes This document describes the commands that Klipper supports. 74M103: Turn all extruders off, Extruder Retraction 12. This guide covers essential commands and firmware tips Now I don't want to wait until 160 to get started, so I did wait for 100, then start all the other stuff, eg pinda warmup etc, and meanwhile, the nozzle can get up to 160, so that the last Hi, I’m trying to read a chamber temp sensors value during the execution of my print start macro. For a full stop use M112. I wanted to wait for the extruder but not the bed. The generated gcode uses m104 (heat but don't wait) to set the temp. yzc, ert, vyi, zjd, adh, nsk, hgx, svm, ddw, yij, hvk, ruv, inn, qmz, jip,